I got the very last scheduled donation boxed up yesterday, and today it hits the post office. Not a moment too soon, since The Show for the Cure is March 24! This is much, much closer than I am comfortable with, and it was a combination of poor planning and !@#$%^-stupid-boots! Boots can be time consuming under the best of circumstances, and then I had to remake one particular boot twice; once because the tabs were on the wrong side* and again because I dyed it too dark. I also remade part of the five point breastplate to correct some fit issues and lengthened the crown piece of the bridle.
But it's done, thank goodness, and will ship today along with a few extra goodies. Here are a couple of photos:
Now that both donations are out of the studio, it's time to really dive into the next project: a cross country/jumper set for WeeJay! I'll be doing more boots, of course, and another five point breastplate. I finished the figure eight bridle while I waiting for various parts of that last !@#$ boot to dry (and watching Frasier).
Please excuse the poor studio photo - this was taken indoors at night with the flash.
Compare to the two bridles below, both finished in March of last year.
The reins are slimmer on this year's bridle because I've gotten more confident when lacing reins and the buckles now have tongues, but otherwise there's not much difference, is there? I haven't decided if that's a good thing or a bad thing. I hadn't cleaned up the edges on the 2011 bridles yet, if anyone wonders about the light edges on some straps. I have to trim lace for strapgoods by hand and those edges are the result of dye not soaking all the way through. From what I've read, this is a common complaint with Eco-Flo dyes. It's not really a problem for me, though. I dip my brush back in the dye and run it along the edges before sealing.
*Equine legwear is always worn with fasteners (buckles, velcro, etc) on the outside, with loose ends pointed behind the horse to prevent injuries and help keep the protective gear from being torn off by another foot. The boot in question was for the left rear leg; when the tabs were on the outside of the leg, they pointed forward. It would be much easier for something to tear them off as the horse is moving forward, over a jump say, than if they were pointed towards the rear.
But it's done, thank goodness, and will ship today along with a few extra goodies. Here are a couple of photos:
Please excuse the poor studio photo - this was taken indoors at night with the flash.
Compare to the two bridles below, both finished in March of last year.
The reins are slimmer on this year's bridle because I've gotten more confident when lacing reins and the buckles now have tongues, but otherwise there's not much difference, is there? I haven't decided if that's a good thing or a bad thing. I hadn't cleaned up the edges on the 2011 bridles yet, if anyone wonders about the light edges on some straps. I have to trim lace for strapgoods by hand and those edges are the result of dye not soaking all the way through. From what I've read, this is a common complaint with Eco-Flo dyes. It's not really a problem for me, though. I dip my brush back in the dye and run it along the edges before sealing.
*Equine legwear is always worn with fasteners (buckles, velcro, etc) on the outside, with loose ends pointed behind the horse to prevent injuries and help keep the protective gear from being torn off by another foot. The boot in question was for the left rear leg; when the tabs were on the outside of the leg, they pointed forward. It would be much easier for something to tear them off as the horse is moving forward, over a jump say, than if they were pointed towards the rear.